CorefinityCorefinityDocs
Open the Control PanelControl Panel
Dashboards · 3 of 5

Time range and scope

Choose the period a dashboard's charts cover, and which client, cluster or site each widget reads.

On this page

Before you start

  • You change only your own dashboards: see Home dashboard.
  • The dashboard has a widget that covers a period, such as a chart. Without one, the time range chips are not shown.

Set the dashboard's time range

  1. Choose a range

    Choose 1 h, 6 h, 24 h, 7 d, 30 d or 90 d above the widgets. For your own dates, choose Custom, enter From and To, and choose Apply range.

Every chart and count over time follows the range, and it is saved with the dashboard. Custom dates are in UK time: up to 400 days, within the last 2 years.

Widgets without a period, such as Open tickets, always show the present.

Give one widget its own scope or range

  1. Choose what it covers

    Open the widget's … menu and choose Configure…. Under What it covers, choose one of the choices in the table below, then search for the client, cluster or site by name.

  2. Choose its range

    Under Range, choose a period, or Follow the dashboard to go back to the dashboard's range. Choose Save.

A widget with its own range shows it as a chip beside its title, and no longer changes with the dashboard's range.

What it coversWhat the widget reads
Everything I can seeEvery client, cluster and site you have access to.
One clientAn organisation and its sites.
One clusterA CoreCluster and the sites on it.
One siteA single site, every environment.

Each widget offers only the choices and periods it can show: the Widget catalogue lists them.

Was this helpful?
Open in ClaudeOpen in ChatGPT